Working Principle of Totally Enclosed Weighing Coal Feeder - Chapter 2 At the same time, 4-20mA current signal proportional to the flow is output to the built-in software PID regulator of the weighing controller. The regulator performs self-tuning operation according to the parameters set by the user, and outputs the control current to the frequency converter controller to change the coal feeding ...
Reasons for ammonia blocking denitration spray gun-chapter 2 Ammonia blocking the spray gun may be caused by the following reasons Phenomenon: One is left or right. Reason for. A. The fan control hole on the side of the air cap is blocked B. The air cap is damaged. When using ammonia spray gun, it is necessary to spray corrosive reducing agent to the area between 850 ℃ and 1050 ℃ in the boiler fur...
During the 4th World Smart Conference, the "China New Generation Artificial Intelligence Technology Industry Development Report-2020" was released. The report points out that the development of China's artificial intelligence technology industry has entered a new stage led by the integration of industrial sectors. The deep integration of artificial intelligence and the real economy is becoming a d...
What communication modules are available from LOGO! Communication Module (CM) AS-i, which is described in more detail in a separate document. This communication module has four virtual inputs and outputs and acts as an interface between the AS-i interface system and the LOGO! The LOGO! communication module (CM) EIB/KNX, which is described in more detail in a separate document, is a communication m...
Programmable Controller Periodic Maintenance As a kind of industrial control equipment, programmable logic controller(Allen Bradley 1756-PA72 ControlLogix, Allen Bradley 1756-RM Enhanced Redundancy Module, B&R X20CP1584 CPU, Allen Bradley 1756-L61 ControlLogix Controller) is widely used in all walks of life due to its high reliability. However, due to the working environment and other peripher...
Application of Network Control Technology in Vulcanizer Control System The vulcanizer control system adopts network control. Guilin Rubber Machinery Factory mentioned it around 1995. At that time, it could not be realized due to the limitation of the programmable logic controller (hereinafter referred to as PLC) network system and various reasons. In view of the various defects of the recording co...
Processing of power supply by PLC Power supply is one of the main ways for interference to enter the programmable controller. Power supply interference is mainly generated by impedance coupling of power supply lines, and various high-power electrical equipment is the main source of interference. In situations with strong interference or high reliability requirements. A shielded isolation tra...
The low-pass filter can absorb most of the " burrs " of the power supply . L1 and L2 in the figure are used to suppress high-frequency differential mode voltage . L1 and L2 are reversely wound on the same magnetic ring with equal-length wires , 50HZ The magnetic fluxes generated by the power frequency current in the magnetic ring cancel each other out, and the magnetic ring will not be saturated.&...