Software process Practical application After the system was installed and debugged, it was officially put into use in October 1999. It has been running stably for more than two years and has calibrated nearly a hundred flowmeters (times) without any problems in the control system. Practice has proved that the system has a high degree of automation, and all performance indicators fully meet t...
How the system working Use a volumetric tube to calibrate the flowmeter. In order to accurately reflect the repeatability of the meter at each flow point, according to the national standard GB/T13282, the basic volume of the volumetric tube should be selected according to the following principles: In the formula: VQ——basic volume design value (m 3 ); Qmax—&mda...
The working principle of the system The body of the volumetric tube is a closed volumetric standard made of steel pipes. Its basic volume value refers to the volume of the pipe section between the start detection switch D1 and the end detection switch D2. The volume value is measured by the authorized unit of the State Bureau of Technical Supervision in accordance with the national verification re...
Software and hardware configuration of the control system (1) Hardware part ① Industrial computer IPC In order to ensure the high reliability of the system, Advantech IPC610 industrial computer is selected. The specific configuration is: PIII800MHz CPU, 128M memory, 40G hard disk, MAG17-inch flat-panel display, graphics card with 64M video memory, sound card and speakers (for alarm and prompt), et...
The low-pass filter can absorb most of the " burrs " of the power supply . L1 and L2 in the figure are used to suppress high-frequency differential mode voltage . L1 and L2 are reversely wound on the same magnetic ring with equal-length wires , 50HZ The magnetic fluxes generated by the power frequency current in the magnetic ring cancel each other out, and the magnetic ring will not be saturated.&...
Processing of power supply by PLC Power supply is one of the main ways for interference to enter the programmable controller. Power supply interference is mainly generated by impedance coupling of power supply lines, and various high-power electrical equipment is the main source of interference. In situations with strong interference or high reliability requirements. A shielded isolation tra...
Application of Network Control Technology in Vulcanizer Control System The vulcanizer control system adopts network control. Guilin Rubber Machinery Factory mentioned it around 1995. At that time, it could not be realized due to the limitation of the programmable logic controller (hereinafter referred to as PLC) network system and various reasons. In view of the various defects of the recording co...
Programmable Controller Periodic Maintenance As a kind of industrial control equipment, programmable logic controller(Allen Bradley 1756-PA72 ControlLogix, Allen Bradley 1756-RM Enhanced Redundancy Module, B&R X20CP1584 CPU, Allen Bradley 1756-L61 ControlLogix Controller) is widely used in all walks of life due to its high reliability. However, due to the working environment and other peripher...
What communication modules are available from LOGO! Communication Module (CM) AS-i, which is described in more detail in a separate document. This communication module has four virtual inputs and outputs and acts as an interface between the AS-i interface system and the LOGO! The LOGO! communication module (CM) EIB/KNX, which is described in more detail in a separate document, is a communication m...
During the 4th World Smart Conference, the "China New Generation Artificial Intelligence Technology Industry Development Report-2020" was released. The report points out that the development of China's artificial intelligence technology industry has entered a new stage led by the integration of industrial sectors. The deep integration of artificial intelligence and the real economy is becoming a d...